Description
Pick-up Pulsar Coil Fit For Kawasaki KLF220 Bayou 220 1988-1995 #.59026-1088
Features:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement to your original unit.
Plug-and-play, direct fit, easy installation.
Often unavailable from the OEM manufacturer.
All products shipped are tested.
Specifications:
Condition: Aftermarket 100% Brand New
Quanity: 1PC
Type: Pick up pulsar coil
Resistor: 120 Ohms
Dimensions:
Height: 19mm
Length: 26mm
Width: 21mm
Bracket center to center: 35mm
Wires length: Approx.1170mm
Other Specifications:
Number of wires: 2
Number of plugs: 1
Number of pins: 2
Replacement Part Number:
59026-1088
Fits Models:
Fits Kawasaki KLF220 Bayou 220 1988-1995
Package includes:
1x Pick up pulsar coil
Note:
Not following these instructions may result in damaging the part or other components on your vehicle.
-By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
-Insulate your solders with heat shrink.
-Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
-Rotate the fly wheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010 in.
-If no spark or erratic spark, switch the wires at the plug.
Features:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement to your original unit.
Plug-and-play, direct fit, easy installation.
Often unavailable from the OEM manufacturer.
All products shipped are tested.
Specifications:
Condition: Aftermarket 100% Brand New
Quanity: 1PC
Type: Pick up pulsar coil
Resistor: 120 Ohms
Dimensions:
Height: 19mm
Length: 26mm
Width: 21mm
Bracket center to center: 35mm
Wires length: Approx.1170mm
Other Specifications:
Number of wires: 2
Number of plugs: 1
Number of pins: 2
Replacement Part Number:
59026-1088
Fits Models:
Fits Kawasaki KLF220 Bayou 220 1988-1995
Package includes:
1x Pick up pulsar coil
Note:
Not following these instructions may result in damaging the part or other components on your vehicle.
-By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
-Insulate your solders with heat shrink.
-Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
-Rotate the fly wheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010 in.
-If no spark or erratic spark, switch the wires at the plug.